1994 Johnson/Evinrude Electric outboards Service Manual, Page 21Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 21

Battery Installation Install the battery near the motorMount the battery in ventilated case and attach the case to the boatA
m) Ga1620 ft(4,96,1 m) GaPCEX061 Battery Connections Before making any electrical connections, be sure the speed control
is turned to the OFF position Some models are equipped with battery clamps or ring terminals to allow direct connection to
batteryIf clamps are required, order clamp kit, PIN 390926[]] On 12 volt models, the red cable should go to the battery positive
(+) terminal and the black cable should go to the battery negative (-) terminal On 1224 models, the red cable should go to
No1 battery positive (+) terminal and the black cable to No.2 battery negative (-) terminalThe white 12 volt cable is connected
to both the No.1 battery negative (-) terminal and the No.2 battery positive (+) terminalThe boat wiring must be protected
by an adequate fuse or circuit breaker installed near the batteries NoteProvide separate batteries for the electric outboardIf
a 1224 Volt electric outboard and gasoline outboard MUST share battery, the gasoline outboard must be connected to the No.2