1994 Johnson/Evinrude Electric outboards Service Manual, Page 23Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 23

Motor-to-Guide AdjustmentBow Mount Except HBF2 1After installing bow mount model, raise it until it contacts the motor rest
have long skeg with the point cut offStandard-Thrust motors have skegs shaped as shown in andthe narrower skeg being on the
HBF2 model 3If the distance is less than dimension listed in chart, loosen the forward cable nut and tighten the rear cable
nutloosen the rear cable nut and tighten the forward cable nut GID 4If the distance is greater than dimension listed in chart,
5When the adjustment is correct, torque one cable nut to 60 inIbs(6,8 Nm) without disturbing the dimensionRecheck the contact-point-to-parting-line