1994 Johnson/Evinrude Electric outboards Service Manual, Page 28Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 28

Introduction This section consists of three basic elements which will help you diagnose and locate problems in electric outboards
indicates continuity or very low resistance[] This symbol indicates no continuity or very high resistance (00) Motor Speed
TestAll Models INote For this test, leave the battery cables connected and submerge the motor in waterA propeller must be
in place to properly load the motor1Connect to 50 amp ammeter between the electric outboard RED cable and battery positive
(+) terminal2If equipped, move the 1224 volt switch to "24 V" position 3Turn the speed control switch slowly through all
speedsNote the ammeter reading at each speed The current draw should be different at each speed setting4If the electric outboard
does not operate at each speed setting, or if the current draw and RPM are not different at each speed setting, note the