1994 Johnson/Evinrude Electric outboards Service Manual, Page 32Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 32

1224 Volt SwitchFoot Control Models INote To avoid damaging components or troubleshooting equipment, disconnect the battery
SwitchHand Control Models INote To avoid damaging components or troubleshooting equipment, disconnect the battery cables
before proceeding 1Remove the steering housing cover[] 2Use 1a inAllen wrench to remove the control shaft set screwRemove
the control shaft and forwardreverse lever to access the 1224 volt switch3Use an ohmmeter calibrated on high ohms scale or
continuity light to test continuity[]] []] With switch set on 24 volt, meter must show continuity when connected between
the two RED leads With switch set on 12 volt, meter must show continuity when connected between the center RED lead and the