1994 Johnson/Evinrude Electric outboards Service Manual, Page 40Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 40

Resistor Wire12 Volt Hand Control Models INote To avoid damaging components or troubleshooting equipment, disconnect the
on the speed control switch are as shown (terminal side of switch) 5Connect the ohmmeter between terminals "3" and "4" The
meter should show 1.0-1.2 ohms resistance The meter must show no continuity between either terminal and the motor tube c::::::J
c::::::J c::::::J c::::::J 6Replace the resistor wire if your test results are different7Refer to Section for assembly information