1994 Johnson/Evinrude Electric outboards Service Manual, Page 41Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 41

A c:::::J c:::::J c:::::JMotor Tube WiringHand Control Models INote To avoid damaging components or troubleshooting equipment,
"4", 12 Volt, terminals "4" and "3", 24 Volt): The meter should show 0.36-0.44 ohm resistance If measured resistance is significantly
different and motor does not respond to speed control change, replace resistor7Refer to Resistor Assembly, Except HBF2, Page
2-21, if your test results are different []] 8Connect the ohmmeter to the motor tube and alternately to terminals "1" thru
"4" of the speed control switch (terminals "2" thru "4", 24 Volt): The meter must show no continuity If the meter shows continuity,
inspect the motor leads, adapter assembly, and motor tube wiring for grounded condition[]] 9With the speed control switch
in the highest speed position, connect the ohmmeter between the RED lead terminal "A" on the speed control and the forwardreverse