1994 Johnson/Evinrude Electric outboards Service Manual, Page 42Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 42

Motor Tube WiringFoot Control Models, Except HBF2 INote To avoid damaging components or troubleshooting equip- ment, disconnect
GREENWHITE 18-Galeads: The meter should show 0.36-0.44 ohm resistance If measured resistance is significantly different and
motor does not respond to speed control change, replace resistor 6Refer to Resistor AssemblyExcept HBF2, Page 2-21, if your
test results are different 7Connect the ohmmeter between metal part of the steering housing or tube and each wire terminal
location: The meter must show no continuity If the meter shows continuity, inspect the motor leads, adapter assembly, and
motor tube wiring for grounded condition !1IJ 8Remove light bulb from socketConnect the ohmmeter between the RED 14-Gaand