1994 Johnson/Evinrude Electric outboards Service Manual, Page 43Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 43

Motor Tube WiringHBF2 INote To avoid damaging components or troubleshooting equipment, disconnect the battery cables before
assembly 4Connect the ohmmeter between the GREEN 18-Gaand GREENWHITE 18-Galeads: The meter should show 0.5-0.6 ohm If measured
resistance is significantly different and motor does not respond to speed control change, replace adapter assembly rn 5Connect
the 14-Ga, GREEN 18-Ga,the motor tube and ohmmeter between alternately to RED and GREENWHITE 18-Gawires: The meter must show
no continuity If the meter shows continuity, inspect the motor tube wiring for grounded condition 6Connect the ohmmeter between