1994 Johnson/Evinrude Electric outboards Service Manual, Page 44Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 44

Resistor AssemblyExcept HBF2 Only perform this check after completing Motor Tube Wiring checks INote To avoid damaging components
to test the condition of the resistor 4Connect the ohmmeter between the RED and the GREEN resistor terminals: The meter should
show 0.17-0.23 ohm If measured resistance is significantly different and motor does not respond to speed control change,
replace resistor [] 5Connect the ohmmeter between the GREEN and GREEN WHITE resistor terminals: The meter should show 0.36-0.44