1994 Johnson/Evinrude Electric outboards Service Manual, Page 52Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 52

[] 12Connect second meter lead to GREENWHITE 18-Gawire at speed control switch terminal "3"Move speed control switch to speed
INotel Completely reseal wire at test area with OMC Black Neoprene Dip 4Connect second meter lead to ONOFF switch center
terminal: Meter must show continuity 5Connect second meter lead to ONOFF switch top terminalPush switch to ON position Meter
must show continuity If meter shows no continuity, repairreplace battery cables or ONOFF switch 6Remove steering housing
coverConnect second meter lead to pin that will pierce wires at splicesPush switch to ON position with speed control at 3,
2, and 1Test RED, GREEN, and GREENWHITE leads at both sides of splices in steering housing Meter must show continuity If
meter shows no continuity, repair or replace base-tosteering-housing wire I Note Completely reseal wire at test area with
OMC Black Neoprene Dip rn 7Connect second meterON: to the top starboard brush lead LeadPush ONOFF switch to Meter should