1994 Johnson/Evinrude Electric outboards Service Manual, Page 76Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 76

[]]] 6Install the retaining pin using suitable press INote Be sure the electrical wires are not damaged by the retaining
to remove any looseness in bearingsTighten screws to 35-45 in Ibs(4,0-5,1 Nm)9Remove three short brass colored screws from
rack assemblySeparate rack cover, rack housing, and the rack 10Install rack housing in steering housing with two long (silver
colored) screws on port side at ilL" locationsinto the original threadsbefore turning it forwardIf the screw is allowed to