1994 Johnson/Evinrude Electric outboards Service Manual, Page 80Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 80

Adjust steering control cable as follows: Steering Cable AdjustmentExcept HBF2 1Start with the adjustment nut approximately
180 clockwise (TO STARBOARD)Motor should have EQUAL TRAVEL TO PORT and TO STARBOARD 7If necessary to equalize travel to port
and starboard, the cable can be adjusted by turning the adjustment nut as shown 8Turn motor to straight-ahead positionWires
must exit the motor tube on the port side of the direction indicator driver as shown on page 3-23 and be connected to terminals
with the motor in this position Wires must be connected with the motor at the straightahead position so they will not be
pulled tight and damaged when motor is turned 180 in either direction 9If steering cable or wires have been replaced, the