1994 Johnson/Evinrude Electric outboards Service Manual, Page 90Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 90

General Safety Warnings If external heat is required to service any component, allow the component to cool to the touch before
fastener (locknut or patch screw) if its locking feature becomes weakDefinite resistance to turning must be felt when reusing
locking fastenerIf replacement is indicated, use only authorized replacement or equivalentTo prevent possible damage, make
sure all wiring is properly routed and clamped in its original position away from rotating motor componentsWhen using shop
air for cleaning or drying parts: Be sure air supply is regulated to not more than 25 PSI (172 kPa) Be sure you use appropriate
eye protection to avoid personal injuryBefore working on or removing any electrical parts, disconnect the battery cables