1994 Johnson/Evinrude Electric outboards Service Manual, Page 95Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 95

Installation 1Clean the threaded area of the motor tube using OMC Cleaning Solvent 2Install motor tube seal sive sealant
tube7Tighten adapter on motor tube[] 8Align adapter set screw hole with existing dent in motor tube to set approximate motor
alignment9Set motor offset using the procedure on Page 4-10 10Remove motor from adapterApply OMC Screw Lock to set screw
and installTighten set screw to 30-40 inIbs(3,4-4,5 Nm)11Install motor as described on Page 4-512Reconnect motor tube wires