1994 Johnson/Evinrude Electric outboards Service Manual, Page 111Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 111

'16 in(7.9 mm) 2Bend two paper clips as shown to make brush and spring holders 3Assemble brushes and springsUse the paper
fiber thrust washer on drive end side of armature shaft8Install new a-ring on drive end head assemblyInstall drive end head
assembly onto drive end of armature shaftBe sure the die marks on the commutator end head assembly and the skeg centerline
are in alignment with the marks on the field assembly9Position new a-rings on thru-boltsInstall and tighten thru-bolts to
torque of 40-45 inIbs(4,5-5,0 Nm)& 10If the adjustment screw has been removed, adjust the armature shaft end playas described