1994 Johnson/Evinrude Electric outboards Service Manual, Page 117Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 117

2Bend two paper clips as shown to make brush and spring holders IJ1] 1141 3Assemble springs and brushes in adapter Use the
not to pinch your hands or fingers between field and adapterTurn field assembly so index marks on bottom of field and adapter
are aligned 7Install fiber thrust washer on armature shaft 8Place new a-ring on field assembly 9Install drive-end end cap
onto armature shaftAlign skeg with motor tube 10Place new a-rings CD on thru-bolts Q)Install and tighten bolts to torque