1994 Johnson/Evinrude Electric outboards Service Manual, Page 124Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 124

Assembly 1To replace the latch release rope, cut new rope 44 in(112 em) longHeat ends of rope to prevent fraying 2Tie knot
washer between the bow arm and deck bracket on the starboard side8Align the deck bracket, bow arm, cable drum, and washerApply
OMC Triple-Guard grease to the pivot pinUsing press, install pivot pin from port to starboard making sure groove in pin is
under set screw hole9Apply OMC Screw Lockto the set screw and installTorque set screw to 40-60 inIbs(4,5-6,8 Nm) 10Position
the motor tube bracket in the bow armThe hinge pin must be on the port side of the bow arm 11Apply OMC Triple-Guard grease
to the pivot pin and install using press 12Center the pivot pin in the assemblyApply OMC Screw Lockto the set screw and installTorque