1994 Johnson/Evinrude Electric outboards Service Manual, Page 133Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 133

Rotary Switch ServiceExcept HBF2 Removal []] 1Push plastic shaft back from the switch with flat blade screwdriver 2Loosen
[]] 1Attach the switch wires using the diagram at the end of this section for correct wire routing and locations2Use only
rosin core solderDo not use an acid core solder m 3Install the switch in the pedal.onPosition shaftwasher lock between switch
and pedalPosition nut switch 4Tighten the nut to torque of 40-45 inIbs(4,5-5,1 Nm) 5Position speed control wheel in pedal