1994 Johnson/Evinrude Electric outboards Service Manual, Page 137Get this manual

1994 Johnson/Evinrude Electric outboards Service Manual, Page 137

Pedal and Base ServiceAll Models 1To replace either the pedal or the base, remove all of the attached components as described
OMC Triple-Guard grease to the bushings and hinge 6Install the hinge pin using suitable pressing pin and press Hold the wires
against the pedal to prevent damage to the wires, and correctly position the wires as the pin is pressed in placeThe wires
will loop over the pin, then down to the speed control switch 7Install components as described individually in this section8To