1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 41Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 41

Submerged Engines Engine Dropped Overboard (Not Running) If engine is recovered from water immediately, it must be serviced
horizontal position (spark plug openings down) and work out all of the water by slowly rotating flywheel approximately 20
times or until there are no signs of water5Drain carburetorsplace engine in upright position and remove carburetors for disassembly
and draining6Starters, electrical connectors, and all electrical equipment should be completely disassembled, cleaned, flushed
with fresh water, treated with water displacing electrical spray, and thoroughly dried before assembly7Inject outboard lubricant
into spark plug holes8Reassemble parts you removed and disconnectedStart engine (follow starting instructions) and run V2
hour using the "break-in" fueloil mixtureRun the engine on "break-in" fueloil mixture for approximately .three hours after
servicingSee Break-in Procedure in this SectionFor models withIf oil line has become disconnected, the oil line must be purged