1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 45Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 45

Throttle Control Rod 1With the engine not running, ensure that the idle speed screw is firmly against its stop and both carburetor
fully counterclockwise to minimum slow speed position r:;;;l 2Attach throttle cable to throttle lever upper hole using pin
and cotter clipCotter clip must be installed parallel to raised rib on lever 3Hold throttle twist grip in full SLOW positionWith
idle speed screw on its stop, pull firmly on cable to remove backlashRotate cable bracket to align with mounting screw holer:;-:;l
4Turn cable bracket two revolutions toward cable end to LJ preload linkagePlace flat washer between cable bracket and intake
manifoldInstall bracket screw and torque to 36 inIbs(4 Nm)5Install cable retainer plate and tighten screw securely 6To check
throttle cable bracket adjustment, rotate throttle twist grip several times and verify that the idle speed screw touches