1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 54Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 54

8Temporarily install cable retainer and screw 9Check cable adjustment Ifthrottle cable adjustment is too loose, idle speed
shift cable, verify control handle position and neutral lockout index plate orientationlever using the pin and cotter clipas
shown 714With engine in NEUTRAL, install the shift cable to the shift f815Rotate the propeller shaft and shift the gearcase
into FORWARD6Move the remote control handle to full throttle in FORWARD7Apply liberal amount of OMC Triple-Guard grease to
anchor block pocket 19l8Pull firmly on cable casing to remove backlash and adjust cable trunnion nut to locate in anchor
pocket9Temporarily install the anchor pocket cover and screw 10Shift the remote control to NEUTRAL rr:i=J If the gearcase