1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 56Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 56

6Reposition fuel manifold to make room for the routing of electrical cables7Remove fuel connector bracket and lay to the
assembly in position in the grommet r;Ql13 Place battery cable faCing down into grommet with the flat side 110114Place power
tilt and trim electrical cable to the starboard side opening of grommetr;Ql15In the remaining opening, route the remote control
electrical cable and VRO wires r,v 16Lower the grommet into position on the lower engine 17Install fuel nipple and bracket
assembly into position on the lower motor cover and retain with screwPlace fuel manifold into its proper position'" After
installation, verify that there is sufficient clearance for all cables to avoid binding or chafing through all engine steering