1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 89Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 89

Component Servicing Anytime the VRO oil supply line has been disconnected from the engine, you must run 50:1 fuelloil mixture
to remove any contamination Install the filter, being careful not to move the pickup assembly on its support rods2With the
pickup assembly out of the reservoir, vacuum test the system to check for air leaks: Carefully, remove the oil hose from
pickup assembly and from engine oil inlet fitting Use low pressure air to purge hose of oil Use cap holder, PIN 329661to
plug pickup end of hose rJl Attach vacuum tester to the engine end of oil line and draw inHg vacuumThe oil system is good
if it can maintain inHg vacuum for at least five minutesBefore installing pickup assembly, check pickup height 1.8 gallon