1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 91Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 91

rv 4Install and secure fewin(25 cm) lengthloose end,(6,35 mm) 10 of V4 inI.Dclear vinyl hoseinches from the measure carefully,
finger pressure on the outlet hose At 800 RPM, the oil level in your hose should drop in(25,4 mm) in approximately five pulses
At full throttle, the oil level in your hose should drop in(25,4 mm) in approximately three pulses7If your results vary,
check the pulse limiter fitting before replacing the pump8If you remove the pump, carefully cut the hose to avoid damaging
the fittingWhen installing, use ratchet clamp on the oil supply hoseTorque the screws, pump-to-bracket, to 18-24 inIbs(2-3