1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 101Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 101

8Check for correct positioning of float levelFloat level controls the height of fuel in the float chamber and is very critical
to dimension shownTo adjust, bend tab on float arm where tab contacts float seat15 803406 Bend Float Lever Tang to achieve
proper dimension CD 1Va into 15a in(28-41 mm) 10Install float chamber and new gasket11Apply OMC Locquic Primer and OMC Screw
Lock to the threads of four float chamber screwsInstall the screws and torque in an "x" pattern to 25-35 inIbs(2,8-4,0 Nm)Installation
Base of Carburetor Body Note Do not use sealer on carburetor gaskets Replace any fuel hoses if deteriorated or damaged 1Install
new carburetor flange gaskets2Install primer hoses to carburetor nipples3Install carburetors on manifold studs, and secure
with lock washers and nuts4Install fuel hoses on carburetors, and secure, using new clamp and OMCTie Strap Installation Tool,