1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 105Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 105

Assembly '4l1Place leaf valves on leaf plateIf new valves do not seat on the leaf plate, turn the leaf valves over r:=:J
two screws near center of leaf stopDo not tightenf6l6Hold leaf valve assembly in horizontal positionThis will usually align
leaf valves over ports in leaf plateTighten the two screws evenly1254 [2] 7Use sharp pencil to mark the edges of leaf valves1sl8Use
pencil eraser to gently open the leaf valves to check the alignment of the valve over the portValves should be spaced evenly
over portIf not, loosen mounting screws and reposition leaf valve9After leaf valve is positioned properly, install remaining
screwsTighten all screws evenly to torque of 25-35 inIbs(3-4 Nm)10Apply OMC Locquic Primer and OMC Nut Lockto the leaf plate
assembly to manifold screws11Using new gaskets installed dry, position each leaf plate assembly and torque the screws to