1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 126Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 126

Ignition Component ReplacementCD IIAmp i twist and remove all spark plug leadsbeing replaced"" 1To avoid accidental starting
if necessaryf811gl9Route leads and install clamp plateand spiral All component leads must be routed through clamp and plate
in single layer, not twisted or crossed over another lead10Apply OMC Nut Lock to the threads of the five ignition plate screwsInstall
the ignition plate on the retainer plateTorque five retaining screws to 25-35 inIbs(2,8-4,O Nm)11Check for sufficient slack
on ignition component leadsRoute component leads through wire clamps12Position OMCLocating Ring, PIN 334994, over machined
bosses on the ignition platePush the locating ring in toward the component to be installedHold the ring in place and pull
the component out toward the ringTighten screws to torque of 15-22 inIbs(1,6-2,4 Nm)13Repeat Step 12 for each component Safety