1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 139Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 139

STEPSENSOR COIL TEST Ground Test [!!] 1Disconnect Amphenol connector: Rope or Amp, the 5-pin connector 12 Amp, the 3-pin
engine groundRefer to following chart for terminal locationCrank engine and observe meter reading at each connection: Any
reading indicates sensor coil or leads are grounded Locate and repair ground, or replace sensor coilRope or Amp PCE0068 4If
no reading is indicated in Step 3, go to Output TestOutput Test 1Set peak-reading voltmeter to "POS" and "5", or "SEN" and