1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 163Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 163

[";';l 1440, 48, 50Apply OMC Gasket Sealing Compound to outside diameter oftemperature switch and install in cylinder headInstall
oil and press new lower main bearing onto the crankshaftWhen pressing on the bearing, support the crankshaft between the
two lower counterweights and press against the lettered side ofthe bearingInstall the retaining ring in groove of the crankshaft
with sharp edge of the ring facing away from bearing Oil the upper main bearing surface of the crankshaftSlide the upper
main bearing onto the crankshaft with seal facing the flywheel end of crankshaft r:;;;l 21Lightly coat the center main journal
of the crankshaft surface with outboard lubricantInstall both halves of the center main bearings 120122Place the sleeves
around the bearings with retaining ring end of the sleeves facing bottom of the crankshaftSecure the sleeves together with