1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 198Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 198

f813Mark the position of the water tube for correct reassemblyRemove the water tube cover screwsSeparate the water tube cover,
exhaust housing '5l5Install the two lower side mounts to the exhaust housingthe screws to torque of 18-20 ftIbs(25-27 Nm)Install
the thrust mount to the housing and tighteh the screws to torque of 60-84 inIbs(7-9 Nm)6Check condition of the shift rod
seal necessaryInstallation and replace if !.i1l1Position the exhaust housing in the swivel bracket assemblyApply OMC Nut
Lock to threads of the upper mount screwsPosition the ground lead CD under the center screwTighten the screws to torque of
18-20 ftIbs(25-27 Nm) tI mount bracket screwsInstall and tighten the screws to a torque of 18-20 ftIbs(25-27 Nm)f1l 3Install
the port and the starboard lower mount bracket 4Install the gearcase as described in Section 65Install the powerhead as described