1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 203Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 203

C0A2956 Install the steering friction thrust ringbevel side up in the swivel bracketThread the steering friction screw in
teethPlace the lower thrust washer in the lower mount bracketSlide the lower mount bracket on the splines of the pivot shaft
while aligning front of the mount bracket with the steering arm Install the retaining ring on the pivot shaft with sharp
edge of ring facing out 13Lubricate the swivel bracket through the four lubrication fittings with OMC Triple-Guard grease1361
14Slide the steering arm seal onto the steering arm with the word "TOP" facing up 1361 15Position the upper rubber mount,
the upper mount washersand the retaining washers on the steering arm with the word "UP" on the mount facing upBe sure to
place the ground lead between the mount (starboard side) and the steering armInstall and tighten the mount retaining screws