1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 211Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 211

DisassemblyAssembly f311Start by removing all the parts from the housingInspect the housing for cracks or melting, and install
OMC Gasket Sealing Compound to both sides of new impeller plate gasketPosition the gasket and impeller plate on the gearcaseDo
not use the impeller plate gasket on Jet modelApply OMC Gasket Sealing Compound to the impeller plate before installingf812Apply
OMC Needle Bearing Assembly Grease to flat area of the driveshaftInstall the drive camThe sharp edge of the cam is the leading
edge during driveshaft rotation 3Slide the water pump assembly down the driveshaftAlign the impeller housing with the gearcaseRotate
the driveshaft to engage the impeller cam with the impeller, and slide the water pump assembly down over the impellerBe sure
the impeller cam does not fall out of positionVerify that the impeller engages the impeller cam properlySerious powerhead