1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 220Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 220

r;:;J 2Slide the Collar PIN 334985 from OMCDriveshaft Shim Kit PIN 433032 onto the driveshaft with large end touching the
0.004 in(0,10 mm) r;;J 8Check the squareness of the pinion to the driveshaft by holding the gauge bar against the bearing
housing, between the screw holes, while rotating just the driveshaft and pinion assembly and measuring the clearance between
the gauge bar and the pinionReplace the gear set or the driveshaft, as necessary, and repeat the check if variance exceeds
0.002 in(0,050 mm)9Subtract the average clearance measurement obtained in Step from 0.030 in(0,762 mm) to determine the correct
shim thickness requiredSelect fewest number of shims to achieve correct th ickness10Remove the driveshaft from the tool baseRemove
the collar and bearing housing from the driveshaft and add the required amount of shims11Check shimming by reassembling the