1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 221Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 221

Assembly Before beginning assembly procedures, all gearcase components must be thoroughly cleaned and in serviceable conditionRefer
until the washer on the tool contacts the spc:lcer r:;J 4Remove the toolPosition new seal on the pinion bearing retaining
screwApply OMC Nut Lockto threads of the screwInstall the screw and tighten to torque of 48-80 inIbs(5-9 Nm)5Using OMC Forward
Bearing Service Kit PIN 433034 and OMC Drive Handle PIN 311880, install two new forward gear bearings in the gearcase as
follows : Place the gearcase in vertical position on the floorSupport nose of the gearcase with wood Place drive handle through
the step plateAssemble the bearing installer to the drive handle to install the short bearing Place the short bearing on
the installer tool with lettered side of the bearing facing the tool Insert the tool with the bearing into the gearcaseDrive