1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 223Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 223

12 15515 up, insert wedge end of the tool with flat side facing end of detent springWhen the tool is flush with the clutch
13Apply OMC Needle Bearing Assembly Grease to the forward gear thrust bearingPlace the bearing on shoulder of the gear and
install the gear r:;-;l 14Place one of the thrust washers onto the driveshaft with chamfered edge facing downInstall the
thrust bearing Place the remaining thrust washer onto the driveshaft with chamfered edge facing upLightly coat the shim(s)
with OMC Needle Bearing Assembly grease and place them into the bearing housingSlide bearing housing onto driveshaft INotel