1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 236Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 236

Propeller Shaft Bearing Housing Service 1261 1Remove both seals using OMC Puller Bridge PIN 432127 and OMC Large Puller Jaws
bearing1281 3Remove front bearing using OMC Puller Bridge PI 432127 and OMCBearing Puller PI 432130Rest puller plate on top
of housing to support bridge and tighten jaws securely behind bearing4Clean housing and bearings in solvent and dry tho roughlyIf
bearings were not replaced, rotate needles with your fingers to check for freedom of movementInspect O-ring groove and sand
off any sharp edges that would cut O-ring and prevent its sealing5Thoroughly clean the four bearing housing retain ing screws