1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 237Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 237

31 DR2061 12911301 7Oil, then install new bearings in the bearing housing using OMC Bearing Installer, PI 326562 Press against
9Lightly apply OMC Triple-Guard grease to new bearing If the needle bearing in the housing is worn, the bearing and housing
must be replaced as an assembly 1341 1Remove the two driveshaft bearing housing seals using OMC Puller Bridge PI 432127 and
OMC Large Puller Jaws PI 432129Discard the seals1351 2Remove the O-ring from the bearing housing and discard3Clean the bearing
housing in solvent to remove sealer from the seal bore and the O-ring groove '31l1321 4Install new seals back to back in
the bearing housing using OMC Seal Installer PI 326549Apply OMC Gasket Sealing Compound to the metal casings of the seals
before installingInstall the inner seal with flush lip facing toward the bearing housing, then the outer seal with extended