1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 240Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 240

Assembly Before beginning assembly procedures, all gearcase components must be thoroughly cleaned and in serviceable condition
to torque of 48-80 inIbs(5,5-9,0 Nm) 5To install the water intake screen, drop it into the water intake cavity, and push
it down as far as it will go with screwdriver or other suitable tool 14411451 '" 6To prevent personal injury, wear safety
glassesInsert the spring and ball, coated with OMC Needle Bearing Assembly Grease, into the housingPress the ball down with
small pin punch until it is below the detent cross holePush the shifter detent over the ball, withdraw the punch, and force
the shifter detent in until it slides over the detent ballPlace the shift lever in the housing, engaging the shifter detent,
and press the shifter detent all the way inNext, hold the cradle on the shifter shaft with OMC Needle Bearing Assembly Grease,
hook the cradle over the shift lever, and install the shift lever pin 14611471 7 1481 8Place the thrust bearing Q) on the