1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 252Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 252

15 r:t5l 19Remove thrust washer and collar Remove retainer ring if required driveshaft [":;";l 20To assemble bearing to driveshaft,
sure the retaining ring IS seated 21 Using f181 22Place spacer and upper seal carrier assembly onto the driveshaftApply OMC
Triple-Guard grease to two new O-rings and install on upper seal carrierr,gl 23bearing housing cavity with OMC Marine Wheel
Beanng Grease 1201 24Heat the bearing housing slightly with propane torchill touch Press the driveshaft and bearing assembly