1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 265Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 265

6Examine the pulley and the starter housingLook for sharp edges and rough surfaces that could fray the starter ropeFile and
into the loop ofthe rewind springSecure the crank and pin assembly to the starter winder base with the crank retainer screw4Rotate
the crank and pin assembly in the direction shown on the toolWind the spring into the starter winder base until end of spring
contacts the starter winder base 11415Remove the crank retainer screw and the crank and pin assembly from the starter winder
baseRemove the starter winder base from the viseCOA1364 f1516Install the rewind spring into the starter housingLocate the
outer loop CD of the rewind spring on the pin in the starter housingPress down through the holes in the spring winder base