1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 266Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 266

COA1365 f171 8Bend the inside loop of the rewind spring in toward the center of the starter housingEngage the slot of the
onthestarter pawl plate CDPress the other end of spri ng on the boss of the pulleyPosition the starter pawl plate on the
pulleyf21l 13Clean threads of the starter pawl plate retaining screw and nut to remove adhesiveInstall the starter pawl plate
retaining screw Q) and washer into the starter housingTighten screw to torque of 120-144 inIbs(14-16 Nm)Spray threads of
starter pawl plate retaining screw that protrude through the starter housing and threads of the nut with OMC Loequie PrimerApply
OMC Nut Loekto the threads of the nutInstall and tighten the nut securely14Using the shoulder screw, install the rope guide
to the starter housingTighten the shoulder screw securely housingBe sure to place the washers between the rubber mounts of