1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 282Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 282

High Voltage 1191 1n some conditions, the key switch may be shorting (allowing some leakage) to the other terminals in the
ohmmeter on appropriate scaleConnect one meter lead to switch yellowred lead, the other meter lead to switch red leadDepress
switchMeter should show: Low reading when the switch is depressed High reading when the switch is releasedReplace the start
switch if your results vary Neutral Start Switch Test All engine wiring must be disconnected from the switch before proceeding
with this check 1Disassemble the remote controlRefer to Section for disassembly and assembly procedures 201 Calibratetoohmmeter
onterminalMeter should show: one appropriate scaleConnect meter lead each switch High reading when the plunger is relaxed
Low reading when the plunger is depressed 3Replace the neutral start switch if your test results varyReassemble the remote
control"" 4Test ALL functions of the remote control after reassemblyAn undetected problem in the remote control could cause