1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 309Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 309

Trim Gauge Troubleshooting To avoid immediate meter damage, never apply an ohmmeter to an electrical circuit where voltage
ON, check for voltage at key switch "A" terminal: If voltage, check condition of remote control purple 16-gauge leads If
no voltage, check condition of key switch and engine harness 20-amp fuse, PIN 510884 f11 4Turn key switch OFFRemove trim
harness leads from gauge terminals "S" and "G"Calibrate an ohmmeter on low ohms scale and connect between the leadsTest results
should be: engine fully downapproximately 88 ohms, engine fully up approximately ohm: If your values are correct, replace