1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 339Get this manual

1994 Johnson/Evinrude Outboards 40 thru 55 Service Manual, Page 339

If electrical parts are replaced or even removed from the motor, check the following: Wire and High Voltage Lead Routing
tighten firmlyThey keep clamps in position and ends of wires from sparking where lockwashers are called for use them _ Spark
Plug Boots not torn or cracked fully pushed onto spark plug """'lIlIIII_ Sparkavoid rough handling that could Plugs crack
Ceramic part of plug(Sparks may jump across outside of plug All Connections clean Tight (Prevents sparks) I transom area
Electrical Cable Not rubbing on sharp objects enough slack to allow full turning without pull loads on cable (Prevents Sparks)