1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 30Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 30

AnodesTesting and Replacement Erosion or disintegration in salt or brackish water indicates the anodes are performing their
OMC prewired remote control or is part of the OMC accessory wiring harnessThis feature alerts the operator to several critical
operating conditionsDepending on the engine model, the conditions might be: Test Note To avoid possible powerhead damage,
be sure the warning horn is in operating conditionIt is advisable to check the horn at the start of each boating season and
periodically during the season Overheatcontinuous tone No Oilcontinuous short pulses Low Oilshort pulse every 40 seconds
V6Fuel Restrictioncontinuous tone at or near full throttle rn 1harness warning temperature switch Disconnect the horn lead
engine from the 2Connect engine harness half of bullet connector to clean engine ground3With the ignition switch in the ON