1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 63Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 63

I Note Push fuel hose off fuel fittingsdon't pullIf pushing won't separate hose and fitting, carefully cut the hose along
its level is even with the highest mark6Start the engine, and monitor the pump cycles by using fuel pressure gauge or by
putting light finger pressure on the outlet hose At 800 RPM, the oil level in your hose should drop in(25,4 mm) in approximately
seven pulses At full throttle, the oil level in your hose should drop in(25,4 mm) in approximately three pulses7If your results
vary, check the pulse limiter fitting before replacing the pump8If you remove the pump, carefully cut the hose to avoid damaging
the fittingWhen installing, use ratchet clamp on the oil supply hoseTorque the screws, pump-to-bracket, to 18-24 in Ibs(2-3