1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 146Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 146

1 19l 13Inspect center main bearing and split sleeves for excess wear, nicks or scratchesReplace if necessaryf1Ol 14Inspect
new sleeve in OMC Crankshaft BearinglSleeve Installer, PIN 338647, and drive the sleeve onto the crankshaft until the installer
contacts the lower main bearing If the installer sticks on the sleeve after installation, thread OMC Slide Hammer, PIN 391008,
into installer and pull offInspect sleeve surface after installingSleeve must not be used if surface is damaged1Jl 3Lubricate
new driveshaft O-ring and lightly lubricate crankshaft splines with OMC Moly LubeInstall O-ring in sleeve1Jl 4Using external
retaining ring pliers, install bearing retaining ring with sharp edge facing away from bearing5Lubricate the center main
bearings and split sleeves with Evinrude or Johnson Outboard Lubricant and install them in their original positionsThe split