1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 149Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 149

1Note The port head has temperature switch with two wires, the starboard head has switch with one wire23Rotate cylinder block
and install bearings29Lubricate threaded portion of No.1 rod cap screws with Evinrude or Johnson Outboard LubricantAlign
dot on rod cap ith dot on the connecting rodInstall rod cap screws finger tight 1Note Be sure alignment dot on rod cap matches
dot on rod and that both dots face flywheel INote Torquing the screws without OMC Alignment Fixture, PIN 396749, or using
an incorrect procedure could cause permanent damage to the connecting rod and crankshaftTo maintain accurate torque values,
keep torque wrench extension length to minimum30Torque the rod cap screws using OMC Rod Cap Aligning Fi xture, PI 396749Align
the flat marked "set" on the rod engagement stop with the arrow on the frame Move the adjustment knob to setting Rotate adjustment