1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 183Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 183

3Place the a-ring Q) in groove in the impeller housing 4Lightly coat the exterior of the impeller cup with OMC Gasket Sealing
and impeller plate 2Apply OMC Triple-Guard grease to new impeller a-ring Slide the a-ring down the driveshaft until it contacts
the impeller plate 3Apply OMC Needle Bearing Assembly Grease to flat area of the driveshaftInstall the drive camThe sharp
edge of the cam is the leading edge during driveshaft rotation 4Slide the water pump assembly down the driveshaftAlign impeller
slot with the impeller camRotate the driveshaft to engage the impeller cam with the impeller, and slide water pump assembly
down over impellerBe sure impeller cam does not fall out of position INote Verify that the impeller engages the impeller
cam properlySerious powerhead damage will result if impeller cam is displaced5Align the impeller housing with the gearcaseApply